Продам Pluto+ SDR transceiver 70 мгц-6 ггц, на заказ

На заказ 3 недели

Продам легенду - SDR трансивер PLUTO +
Разработка лидера отрасли Open Source RadioLab
Может использоваться как самостоятельно, так и стать ЯДРОМ вашей антидроновой или р\л системы.

В наличии в России - 1 шт

Расширенный комплект, всё что на фото!
Примечание: первые три фото я стащил у производителя, последнее фото - моё, там расширенный комплект!

PLUTO+ SDR Transceiver Radio 70MHz-6GHz Software Defined Radio For Gigabit Ethernet Micro SD Card

PLUTO+ is a software-defined radio platform that supports 2TX and 2RX, supports Gigabit Ethernet and Micro SD card. It refers to the design for well-known ADI ADALM-PLUTO and improves its shortcomings.

- ADC/DAC: AD9364
- 2 Transmit, 2 Receiving channel
- RF Range: 70MHZ~6GHZ
- Ref Clock: VCTCXO 40MHZ 0. 5ppm
- SOC: for Zynq7010 FPGA: 28k
- RAM: 512M
- FLASH: 32M
- USB: 2. 0, support OTG
- Ethernet: 1000Mb
- Micro SD can use to boot
- DC IN: 5V±0. 5V-2A microUSB

Interfaces:

Please note that all IO levels are 1. 8V.
When using the official firmware for ADI-PlutoSDR, please connect to URST-MI052.
When using Pluto+ firmware and need to support Ethernet, please connect URST-MIO46
When using SD card to boot, please connect SD-H to 1V8
When using JTAG to debug, please connect JTAG# to GND
Please connect EXCLK to GND when using external reference clock input

PTT Key Port:

- PTT drives optocouplers through GPIO0 (MI00), which requires an external relay or control circuit.

DFU KEY:

-At any time, you can press the DFU button and power on PLUTO+ again to enter the DFU mode, but you need to connect the URST jumper to MI052.

Ref CLK input IPEX:

- You can connect a cable to input an external high-precision reference clock for AD9363 through the IPEX interface.
- The main level should not exceed 3. 3V, and the EXCLK jumper needs to be connected to GND to turn off the built-in clock

Calibrate the Frequency of Built-in VCTCXO:

-The frequency of the 40M clock can be fine-tuned by adjusting the adjustable resistor next to the VCTCXO, provided that you have a reference signal source.

Micro-SD:

Support booting via SD card, need to connect SD-H jumper to 1V8.

- -
Отправка после 100% оплаты на карты СБЕРА или ВТБ по всей России Почтой, СДЕКом или Боксберри.